These are just a few of the Utv's I've repaired. Any accessory such as cab, tracks, to bumpers I can install. I fix drivetrain, engine, and runnability issues. I can repair all makes and models. I have the scanner software to diagnose fault codes on all makes and models and also have the ability to program spare keys, change name display, and reset service lights on all can ams.

2014 Polaris RZR 900 XP crew. Connecting rod bearing went out and caused even more damage to the entire engine.

2019 Can Am Maverick Sport 1000. We installed a flip windshield, sport hard roof and rear panel.

2016 Polaris XP 900. Rebuilding the drivetrain.

2015 RZR 1000. Rebuilding the front end. Ball joints,wheel bearings, a arm bushings and brake pads.

Polaris ranger 800 XP. We are replacing the steering gearbox and lower shaft off the power steering unit!

2014 Polaris rzr 900!! Rebuilding the top end

2016 Yamaha Wolverine 700 UTV. The rod bearing on the crankshaft was starting to go out causing a lower-end engine noise.

2018 Yamaha wolverine 850. Installing a winch and windshield wiper kit onto a polycarbonate windshield.

2016 polaris rzr xp 1000 high lifter!! On this machine we installed a full low end clutch kit from EPI.. Removed all the shocks to install a new conversion kit which includes springs and crossover spacers. This kit allows you to fully adjust your suspension by changing crossover spacer position and ride height. Also ran a vehicle report using my diagnostic scanner to show the customer his rpm averages.

2015 ranger 570 polaris. I am installing a plow kit that runs off the winch

2014 arctic cat wildcat trail xt 700 side by side. Pto side connecting rod bearing replacement

2015 ranger xp 900 polaris. New camoplast tracks

Bearing Replacement. 2007 Yamaha Rhino 660 UTV

Front Gear Case Rebuild. 2012 Polaris xp 800 side by side

2013 Polaris RZR 800 Drivetrain Replacement